This mount allows you to get the C-More as close to the gun as possible. No gunsmithing required to install this mount. Simply screw it to the gun and then screw the C-More directly to the mount. Will fit any pre-drilled Ruger .22 handgun.
MKII, MKIII, 22/45 with drilled & tapped receivers. Also fits TacSol Taclite Conversions.
Custom Scope Mount for C-More on a Ruger 22-45
- Get your scope as close to the gun as possible
- Easy Scope Mounting (top holes accept C-More Rail or Slide mount with no modifications.) - Fits just over Ruger rear site
In the Box:
- Allchin Scope Mount
This mount allows you to get the C-More as close to the gun as possible. No gunsmithing required to install this mount. Use factory supplied mounting screws. It is also imperative that the C-More screws do not protrude through the bottom of the mount
Allchin C-More Mount review
Received product on time as expected. The mount came with three screws all the same length. The screw that mounts over the bolt is too long as it is scraping the bolt. Had to back the screw off a few turns to keep it from dragging. Found out that is typical with Allchin. Reached out to Allchin and was told to just cut the mounting screw to fit. A bit disappointing but doable. If not for that i would have rated it higher
Good product but did not work on my gun
My MKII was older without hoes for this to mount to the receiver. Would work good on a newer version MKII or MKIII. This is not the products fault but mine for not checking. I wanted to replace a WEIG-A-TINNY and lower the C-More.
Stellar Product
Another stellar product.
Cmore mount
As for the mount it works great. However the rear screw was too long when fully tightened in my Mark 4 22/45 Lite. It took a little bit of filing to lower it down so it didn't catch on the bolt. Otherwise it works great.
Quick
Love this company! Product was shipped within a hour of me ordering my product!